Pulse of the old telephone to dual tone multiple frequency DTMF Converter worldwide edition support for Unconventional dial | Дом и сад

Pulse of the old telephone to dual tone multiple frequency DTMF Converter worldwide edition support for Unconventional dial | Дом и сад

This convertor is DIALOR2 Global edition, which supports various telephones of different countries and countries.

A dial that supports three other number sequences that were not standardized internationally before the early 1930s, for example; 0987654321; 9876543210; 0123456789;

At present, the international common number order is 1234567890;

This is a kind of pulse signal to audio signal converter specially designed for old dial-type telephone. Through this converter, your old telephone can convert the original pulse signal into a two-tone multi-frequency (DTMF) signal. The number dialed by your telephone can be recognized by modern switches to achieve the purpose of dialing. In this way, your phone is not only used as a decoration, but also can be used in daily life.

In cities or regions where pulse dialing is no longer supported for older dial telephones, it is especially suitable for Internet or fiber optic subscribers.

Easy to install and use, no need to change the telephone. Just connect the two wires of the telephone to the designated terminal and plug in the crystal head of the telephone line. Please refer to the picture below for wiring.

After connecting the line according to the figure above, after lifting the handle of the telephone, the indicator light of the converter will be on (if the indicator light is not on, please refer to the following figure to switch the wiring of L1 and L2) and you can dial the phone. Each time you dial, you hear the same two-tone signal in your earphone as in a modern touch-tone phone.

Version features:

1. "redial" and "*" and "#" functions;

2. 10 commonly used telephone Numbers can be stored in advance;

3, support four international number order dial;

Please refer to the picture above for the wiring method.

DIALOR2.0 is a circuit module that will soon be used again in the old dial-type telephone; It can transform the pulse signal which is not recognized by modern switch into the two-tone multi-frequency signal which is recognized by modern switch. In this way, the collection telephone which can only be used for decoration can be used normally again in daily life.

Please refer to the picture provided above for wiring methods; Due to technical improvement, the converter circuit board you receive may not match the picture; But the connection mode and use method remain the same!

Easy to install and use, no need to change the telephone. Just connect the two wires of the telephone to the designated terminal and plug in the crystal head of the telephone line. Please refer to the picture wiring provided above;

During installation, after connecting the cable and lifting the handle of the telephone, the indicator light of the converter will be on (if the indicator light is not on, please switch to L1 and L2) to make a phone call. Each time you dial, you hear the same two-tone signal in your earphone as in a modern touch-tone phone.

Please note that the indicator light should not go on when the dial is set to the end. Otherwise it's the phone!

The dialing method is the same as the old telephone.

Redial method: Dial 1 and wait for about a second, then release the dial. It's redial;

Dial * # : Hold 2 for about a second and release the dial; It's a dial *;

In the same way, dial 3 is a #;

If the dial number of your telephone is not in the regular order of 123-- 90; Please press "9" to hold for about 10 seconds and then let go. If you hear a long sound "Di", you will hear a beep. Indicates that the converter has recognized and adapted the special number dial of your telephone;