LUCKYYJ Защитная пленка для окон УФ-блокировка термоконтроль матовая стеклянная

LUCKYYJ Защитная пленка для окон УФ-блокировка термоконтроль матовая стеклянная

Lifetime: 5-8 Years

Technique:Digital Printing

Product Type:Glass Window Film

Material :PVC, Waterproof, Fastness

Suitable:Windows, Sliding Doors, Smooth Surface.

Size and Packaging

Size: 17.8 inch (45cm);Sold by Meter. (if you want 45cm*500cm,make quantity 5 please.)

Please measure and record the length and width of each piece of glass you plan to tint first. Suggest buy 5-15% more for waste or scrap.

LUCKYYJ window film use The new strong glue design ., easy to install, gives privacy and decorate while allowing plenty of light in. Meanwhile, YaJing window film will block 96% of UV-Rays,protect your skin and furniture.

Privacy Effect for Different Distance This pattern of window film will provide you a good privacy. It is highly recommended for the privacy needed place, such as a washroom ,bedroom or basement window. You will love to have a DIY with it to decorate your kitchen, living room and front doors etc. Let’s go to dress up you windows!

Step 1. Keep Window or Glass Clean

Step 2. Measure the window and determine size

Step 3. If you need to cut,draw lines the window film with markers. Make sure the edge of the protective film and the glass surface have a 1cm gap.

Step 4. Wet the Window or Glass with water( themore flowing water, the better)

Step 5. Remove the Static Film from backing protect sheet ( Please MAKE SURE you have removed it before you apply the matte window film to glass), if it is difficult to tear off the protective film, you can try to tape the two sides with duct tape and then peel off.

Step 6.Squeegeeaway air bubblesand redundant water with a scraper or hard card (Don't move it again for 24 hours)

Step 7. Much easier than Wall Decals, 2 people work together more efficiently.

Step 8. Enjoy your works! If you want to remove it, simply peel the window film from any corner. It comes off leaving no residue cleanly.

Questions & Answers:

Q1:Why my window film can not cling?

A1:Have not wet the window with water, or have not removed the transparent backing film. Please don't forget to remove the protective film or it will not cling.If you have removed the protective side,you may applied the wrong side. Please paste the smooth side to the window.

Q2:Why there are so many bubbles?

A2:Too less water. Please tear it down and spray a lot of water,the more water,the better.

Q3:Why the edge of my window film began to fell off?

A3:The edge of film is too close to the window. Please leave a small gap(about 1 cm )to let the water flow out so that the film can stick well.