Km300-40 condenser microphone set E300 with 48V Phantom Power on nvp-40 desktop stand and cable to connect |

Km300-40 condenser microphone set E300 with 48V Phantom Power on nvp-40 desktop stand and cable to connect |

Condenser microphone E300 with Phantom Power 48V on the desktop stand nvp-40 and cables for connection provides an opportunity for high-quality recording of vocal or eyeliner.

Desktop stand nvp-40 will allow you to install a condenser microphone E300 at the height you need for ease of use and pleasure from the process of work or creativity.

The microphone is complemented by a pop filter-a special mesh of several layers of thin nylon material, stretched around the oval frame. The device reduces interference from human breathing, removes excess low and high sound frequencies, protects the microphone from dust, lipstick, saliva sound, and therefore helps to improve the quality of the equipment.

The phantom power unit for the condenser microphone provides reliable 48 V power directly from the cable and accurately and completely transmits the audio signal to the sound card. Equipped with a single-channel unit with a microphone input and an output for connecting with a mixer.

Phantom Power is a device for transferring audio data and power over the cable at the same time, so that when recording a voice, during the transmission of sound from the microphone to the computer, no, drone, Echo and other distortion of the recorded sound.

Features:
-Adjust the angle of the microphone;
-Pop filter with double layer of nylon;
-Shockproof Spider holder;
-The holder is equipped with pulling elastic bands for the microphone;
-Height adjustment of the rack;
-Compatible with all kinds of microphone and music recording equipment connected via XLR cable;
-Input and output balance;
-220 power adapter comes complete with phantom power;

Features:

-Height of the rack: 18-30 cm;
-Length of the microphone: 20 cm;
-Orientation pattern: cardioid;
-Connection: Wired;
-Polar pattern: unidirectional;
-Sound frequency range: 20Hz-20 kHz;
-Sensitivity of the drip: -34 DB +-2 dB (1 kHz);
-Output resistance: 150 Ohm (1 kHz);
-Input resistance: more than 1000 ohms;
-Dynamic range: 130 dB, 1 kHz;
-Signal to noise ratio: 78 DB;
-Size: 13x10.5x2.5 cm;
-Microphone gain: from 12db to 35dB;
-Phantom power supply 48V for the microphone: included;
-Connection: Wired;
-Input voltage: 5 V;
-Output voltage: 48 V;
-Input connector: XLR;
-Output connector: XLR;
-Power cable length: 1.4 m;
-Phantom Power dimensions: 9x9x4.5 cm.
-Cables: Included

Included:

-Microphone e300-1 PCs.;

-Desktop stand nvp-40-1 PCs.;

-Holder for microphone pauk-1 PCs.;

-Pop-filter-1 PCs.;

-Cable for microphone XLR (M) - XLR (F) - 1 pc.;

-Cable XLR-Jack 3.5 for microphone-1 pc;

-Adapter from 3/8 "to 5/8" - 1 pc;

-Phantom nutrition-1 pc;

-Power supply from 220 network for phantom power supply-1 pc

Warranty period: 1 month
It is important!!!!! Works only with microphones connected XLR cables.
It is important!!!!! Phantom Power supply provides 48 V voltage on the condenser microphone, but it does not improve the sound quality and does not improve the volume of the microphone.
Attention! Phantom power is needed by condenser microlights, without it they will not work. For dynamic microphones, there is no need for phantom power.