Car Charger Flood Spot Light Work Lamp 1000LM 10W DC 5V 1A 6500K For Outdoor Camping Travel Working Lighting LED | Автомобили и

Car Charger Flood Spot Light Work Lamp 1000LM 10W DC 5V 1A 6500K For Outdoor Camping Travel Working Lighting LED | Автомобили и

Specifications:Package included:

Charging voltage: AC100-240V,50/60Hz

Lithium battery：3.7V DC 4400mAh

Charging Output: DC 5V, 1A

Charging time: About 4.5hrs

Work Time：Max.6hrs

Output Power: 10 Watts

Brightness: Max.1000Lumens

Function：100%-30%-FLASH

Color Temperature: 6500K

Package included:

As the picture show

Batteries：

1. Never attempt to open for any reason.

2. Do not store in locations where the temperature may exceed 40 °C.

3. Charge only at ambient temperatures between 4 °C and 40 °C.

4. Charge only using the charger provided with the tool.

5. When disposing of batteries, follow the instructions given in the section “Protecting the environment”.

7. Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators and other polymer components may be damaged resulting in electrolyte leakage and/or internal short circuiting leading to heat generation causing rupture or file. Moreover do not dispose of the batteries in fire, explosion and/or intense burning may result.

8. Under extreme conditions, battery leakage may occur. When you notice liquid on the battery, proceed as follows: ·- Carefully wipe the liquid off using a cloth. Avoid skin contact.

·- In case of skin or eye contact, follow the instructions below: i. Immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar. ii. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Consult a physician.

Chargers：

1. Use the charger provided with the tool only to charge the battery

2. Never attempt to charge non-rechargeable batteries.

3. Have defective cords replaced immediately.

4. Do not expose to water.

5. Do not open the charger.

6. Do not probe the charger.

Attention：

1.This is not a toy; children should not permit to use it. This is a DIY product, all electronic parts fixed already, any intention of opening work-light or changing work-light design is prohibitive unless a professional electrician.

2.Do not attempt to replace or change or the diode lights! If the protective glass is cracked or broken, it must be replaced before the work light can be used again.