Privacy Window Film Rainbow Flower Static Cling Sliding Glass Door Non Adhesive Anti UV for Home Decoration | Дом и сад

✔ Leaf Pattern Beautify Your Home: With the charming leaf pattern, this window film could really decorate your home greatly. Apart from that, the 3D laser design enables the film create charming light effect when sunshine goes through ✔ Static Cling&Easy Application: This window film is applied by static cling, without any sticky and chemical glues and adhesives. You could easily install it to the window with some water. Let’s start to enjoy the fun of DIY now ✔ Removable&Reusable: The window film could be easily removed without any glue or residues, and can be applied again and again. No more worries about the ugly adhesives on the window ✔ Natural Light In With Little UV Rays: This wind film can effectively reject 96% UV rays to protect your skin and the furniture from fading. Meanwhile, it helps to soften the strong sunlight and allow the natural light in. A really perfect and affordable alternative to strong curtains and blinds in the summer ✔ Privacy Protection: It could add privacy protection to your home by blurring unwanted views while allowing the soft and natural light in. The privacy level is Semi-Private ★★★★☆    Installation Instructions:   1. Measure the surface and cut the film. Leave an extra inch margin each side for an easy adjustment. 2. Clean the target surface thoroughly and make sure the surface is clean enough without any dust. 3. Peel off the transparent backing film along a short side. (Very Important!!!) 4. Spray a lot of water or soapy water both on the SMOOTH side of the window film and the window, then install the window film onto the window. 5. Use the soft towel or squeegee to wipe the film back and forth to make sure that the bubbles and water have been totally removed. 6. Trim off the margins and use a cloth to flatten out the film. Here you go!     How to Peel Off the Clear Backing Film:   Step 1 - Please wet one window film corner and use your fingers to twist it for a while to loosen the attachment between the window film and clear backing film; Step 2 - Please attach a sticky tape to the side of the clear backing film corner (we have also attached a small sticky tape on each roll of window film for your convenience), and then press it for effective attachment; Step 3 - And then you are able to separate the clear backing film from the window film easily.     Note: The window film works only on FLAT, CLEAN, and SMOOTH surfaces. It will not stick on plastic, broken or uneven surfaces. Detailed installation instruction is also printed on the inside of the WXSHSH prducts.