ЭНЕРГЕТИЧЕСКАЯ ПЛАСТИНА ИЗ ВЕРЕТЕНОВОЙ ВОЛЬФРАМОВОЙ СТАЛИ 220x220/235x235/310x310 мм, ПОКРЫТАЯ ПЭИ, ГИБКАЯ ПЛАСТИНА С ПРОДУВКОЙ ДЛЯ 3D-ПЕЧАТИ НА ПОДОГРЕВАЕМОЙ ПЛАТФОРМЕ CR10 ENDER 3.

ЭНЕРГЕТИЧЕСКАЯ ПЛАСТИНА ИЗ ВЕРЕТЕНОВОЙ ВОЛЬФРАМОВОЙ СТАЛИ 220x220/235x235/310x310 мм ПОКРЫТАЯ ПЭИ ГИБКАЯ С ПРОДУВКОЙ ДЛЯ 3D-ПЕЧАТИ НА ПОДОГРЕВАЕМОЙ ПЛАТФОРМЕ CR10 ENDER 3.

Advantages:

Flexible, removable, can stick to magnetics very well. High strength and heat resistance.

Never warp& Never rust.

Easy to get the first layer even for a new user

Suits variety of filaments, especially for PLA and ABS

Free clean- just flex the plate a little then take the prints off after cooled

Fast heater performance, less waiting time after printing.

Material:

100% real Ultem1000（ PEI）amber color, matte surface.-0.2mm thickness - Made in Europe

This spring steel sheet is flat, flexible, stainless stick to magnets very well. 0.4mm thickness

PEI is 3m tape pre-applied, free bubbles.

PEI is applied on steel sheet

Important Information:

1.Recommend print temps

PLA – 60C

HTPLA – 60C

PETG – 70-80C

PCTG – 70-80C

ABS – 100C

2.Product Usage Guidelines

PETG/PCTG/TPU– If you are not careful with your 1st layer you can risk bonding the PETG/PCTG/TPU to the PEI surface. This will damage the surface. To prevent damage to the surface apply hairspray or PVA gluestick before printing PETG/PCTG/TPU on the PEI

Part Removal– Make sure your plate is at close to room temp (under 30C) before removing parts. If you remove when hot it more likely to damage the surface

How to use?

After apply the PEI sheet on our special spring stainless steel sheet, You can simply use 4 clips or magnets to hold it on the heatbed, then enjoy the printing.

Easily remove 3D prints on printer by removing the spring steel plate, flexing it, and popping the print off. It's simple and makes the print removal process much easier.

Items Included:

Spring Steel PEI flexplate(PEI is applied on steel sheet)*1, not include magnetic Base.

Note: Please remove the transparent protective film on the surface before use

Happy Printing!!!