For Audi A1 A6 A7 Q3 Q7 for VW Touareg Original Screen Upgrade Reversing Image Front Rear View Reverse Camera Interface Decoder |

For Audi A1 A6 A7 Q3 Q7 for VW Touareg Original Screen Upgrade Reversing Image Front Rear View Reverse Camera Interface Decoder |

For Audi A1 A6 A7 Q3 Q7 for VW Touareg Original Screen Upgrade Reversing Image Front Rear View Reverse Camera Interface Decoder

Features

- Perfect Integration to Original Equipment
- Dedicated Auto switching Reverse Camera Input
- Plug & Play Installation

Basic function

- Rear-view camera input + track + radar,

- Front camera input + radar,

- DVR (Driver control),

- 360 + CVBS input + left and right power signal output + serial port
 

*Note: All disassembly and assembly processes need to be powered off and the original car protection measures must be taken to avoid damage to the original car parts.
1. Take for Audi A4 as an example: first pry open the decorative strips (the entire strip) of the display and instrument panel according to the specified position with a rubber knife.

2. As shown in the figure below, after prying off the decorative strip, unplug the power cord of the double flashing lights and the air conditioning sensor plug in the air conditioning outlet on the left, and remove the 4 screws in the red circle on the screen with a screwdriver.

3. As shown below: Unplug the original car screen LVDS cable in the red circle, take out the decoder, transfer our LVDS cable, pry out the air conditioning panel in the red circle, and transfer the power protocol line of the decoder.

4. Install the decoder, connect the reversing rear view camera, take the wire and position, check and pack the bare power supply, the product display effect is as follows after recovery.

5. If the customer installs VGA360 panoramic view, both VGA cable and AV lotus head rear view video head are required. (Remember)